Swanstone TRI-1815IS-018 Installation Guide download pdf

4a. Vessel Bowl Mount

Apply a silicone sealer around the base

flange and set bowl into place. Install

faucet, supply lines and drain per manufac-

turer’s instructions.

Tools required:

• Ruler/Tape Measure

• Drill

• Masking Tape

• Safety Glasses

• Screwdriver

• Saber Saw

• 1 -1/4”" Hole Saw

• Caulk/Silicone Adhesive

Vessel Mount and Drop-In Template

Installation, Care & Cleaning

Model TRI-1815-IS Islandia

and Model TRI-1815-HL Halo

2. Drill a starter hole inside of the cutout

line.

1. Select the bowl template that applies to

the installation that you desire. Cut out the

inside of the template. Locate the template

front to rear and right to left on the counter-

top. Make sure that the bowl location will

not interfere with the cabinet below or the

plumbing. Attach the template to the coun-

tertop with masking tape and draw a pencil

line around the inside of the template.

Apply

silicone

here

Apply

silicone

here

3. Using a saber saw, cut inside of the

cutout line. Trial fit to check for proper fit.

4b. Drop-In Mount

Apply a bead of silicone sealer to the under-

side of the sink flange and position into

countertop opening. Install faucet, supply

lines and drain per manufacturer’s instruc-

tions.

Vessel Bowl Mount

Drop-in

RECOMMENDED CLEANING

PROCEDURE FOR SWANSTONE

SOLID SURFACE

Hard To Remove Stains

1. Abrasive cleaners such as Ajax, Comet,

Bon Ami or Bar Keeper’s Friend.

2. The use of an abrasive pad such

as “Scotch-Brite.”

3. For the most stubborn stains, fill the

Swanstone vanity bowl about one-

quarter full with a 50/50

solution of bleach and water. After ten

or fifteen minutes of soaking, drain

solution from the bowl as you wash

and rinse both sides and bottom.

NOTE: DO NOT USE STEEL WOOL OR

METAL SCOURING PADS

Mineral Based Stains

Cleaners designed to remove iron or rust

should not harm Swanstone.

Marks Or Discoloration

WHITE automotive rubbing compound

may be used to remove stubborn marks

or discoloration.

Scratches

Use sandpaper, starting with coarsest grit

and going to finest grit until scratch dis-

appears - blend area in with abrasive fin-

ishing pad.

NOTE: FOR SWANSTONE GRANITES,

Use #9 Fine Finishing Film for Final

blending. Use Paste Wax to Restore Color.

Use of these products will not damage

the Swanstone solid surface. Always fol-

low label directions. If these methods fail

to produce acceptable results, contact the

Swan representative in your area.

1 2

Summary of Contents

Page 1 - Vessel Bowl Mount

4a. Vessel Bowl MountApply a silicone sealer around the baseflange and set bowl into place. Installfaucet, supply lines and drain per manufac-turer’

Page 2 - Undermount Overlap

Working from the topof the countertop1. Select the template that will provide thedesired overhang.2. Position the template onto countertop atthe desir

Comments to this Manuals

No comments

Swanstone TRI-1815IS-018 Installation Guide

Browse online or download Installation Guide for Sanitary ware Swanstone TRI-1815IS-018. Swanstone TRI-1815IS-018 Installation Guide User Manual

Summary of Contents

Comments to this Manuals