Product Warnings Safety Guidelines General Information Installation Procedure Cleaning & Maintenance Warranty InformationRead and Understan
Before cutting the opening in the countertop, make surethe depth of the router bit is adjusted to allow thebearing to ride against the surface of the
Before beveling the opening in the countertop, makesure the depth of the router bit is adjusted to allow thebearing to ride against the sink, just bel
Before rounding the opening in the countertop, makesure the depth of the router bit is adjusted to allow thebearing to ride against the sink, just bel
1 Use 120 grit sanding pads to remove router bitbearing marks, and to blend edges and seams. 2. Use 220 grit sandpaper to remove sandingscratches and
Product Care and CleaningSwanstone solid surface products are stain and abrasionresistant; however, the finish requires reasonable care.Abrasive clean
LIMITED WARRANTYFOR COMMERCIAL APPLICATIONSIf a Swan Corporation product covered by this warrantyis found to be defective in materials or workmanship,
www.theswancorp.comForm # 375 12-11Save these Installation Instructions for future reference.They provide important information on cleaning andmainte
IMPORTANT NOTICE: Indicates that equipment orproperty damage can result if instructions are notfollowed. Read and Understand the ManualIt is the respo
WARNING: Indicates a potentially hazardoussituation which, if not avoided, could result in seriousinjury or death.Eye ProtectionBe sure to use all per
General Tools 2-1/2 hp router (such as Porter Cable 7539). Drill or cordless drill (such as DeWalt DCD940KX 18VVariable Speed Reversible Driver Dril
Vanity Sink InstallationThis procedure provides instructions for under mountinga vanity sink directly to a solid surface countertop usingcolor-matched
Before glue-up, wipe all the sanded surfaces with aclean cloth and denatured alcohol. Remove all dust andlet the surfaces dry completely.8. Select th
To avoid damaging the sink or vanity top, do notovertighten the screws and do not use a screw that istoo long. Use caution if using a variable speed
16. Once the adhesive has cured, remove the clamps.Use the Swanstone Part # VW 0050-000 specialcountersink drill bit and drill pilot holes in theremai
Comments to this Manuals