Swanstone CS-1616 - Installation User Manual

Corner Shower SeatModel CS1616 Product Warnings Safety Guidelines Kit Contents Required Tools Preparation Tips Installation Procedure Cleaning

Care and CleaningThe Swanstone products are stain and abrasionresistant; however, the finish requires reasonable care.Because cleaning products change

LIMITED WARRANTYFOR RESIDENTIAL APPLICATIONSIf a Swanstone product covered by this warranty isfound to be defective in materials or workmanship, after

Save these Installation Instructions for future reference. Theyprovide important information on cleaning, maintenance, andsurface repair of Swanston

800-325-7008 3 The Swan Corporation – SwanstoneThe Swanstone Assurance — if our product isproperly installed and maintained, as stated in theseinstruc

IMPORTANT NOTICE: Indicates that equipment orproperty damage can result if instructions are notfollowed. Read and Understand the ManualIt is the respo

particles from going into the air. Always work in a well-ventilated area. Always use an OSHA approved dustmask when cutting, drilling, or sanding Sw

Preparation Tips The mounting surface must be free of dirt, film,waxes, or any other residues.Caulking Tips Follow the instructions on the caulking

2. Use 2-1/2” to 3” long #12 drywall screws to attachthe 2 x 6 supports to the stud wall, as shown.NOTE: After installing the 2 x 6 wall support, fini

4. Drill six pilot holes at the marked locations, using the3/16” drill bit. Drill through the wall panel and intothe 2 x 6 inch support block install

b. If the wall corner is not exactly 90 degreessquare, it will be necessary to sand the sides ofthe seat in order to achieve a proper fit. Use acoarse